Designer x
Unpacking
1
Arrange your workspace
Choose a room and a workspace for your printer. Make sure your workspace suits the following requirements:
Ambient temperature from 15 to 30 ºC
Ventilation availability
Relative humidity from 30 to 65%
Stable horizontal surface with 30 kg load carrying capacity
Atmospheric pressure from 720 to 790 mm of mercury
Your printer must be kept away from direct sunlight
Grounded mains electric power (AC power) 220V ± 15% (50 Hz) system
2
Take your printer out of a box
Open the top of the box and remove styrofoam from the corners.
 |  |
Take your printer out of the box and place it on the prepared surface. The weight of the printer is about 16 kg, be careful. The printer should stand on feet screwed along the perimeter of the bottom of it.
There are ventilation holes at the bottom of the device. Make sure there are no foreign objects under your printer.
 |  |
3
Remove transportation parts
After unboxing Designer X cut ties inside your printer. Be careful not to damage the drive belt.
 |  |
After unboxing your 3D printer, leave it on the prepared surface for at least 24 hours - do not plug the 3D printer to power prematurely.
We’d recommend you to keep the original box and styrofoam in the event transportation is required.
Was this acrticle useful for you?
Do you have any questions? Write us!
By clicking on the button, you consent to the processing of personal data and agree to the privacy policy.
We use cookies to gather statistics
and make our products better
and make our products better
Good